Spatial diffusion patterns of Protestants in Guangdong since 19th century

地理环境往往会对宗教的扩散和分布产生重要影响.扩散是宗教地理研究关注的一个重要方面,而对具体宗教扩散模式的研究在国内尚属薄弱.对基督教新教自19世纪初传人广东后的空间扩散形态进行分析,发现存在着多种扩散模式.其中,点轴式迁移扩散最为普遍,但中间障碍的存在常常使发展轴线发生变换;等级扩散呈现出按照人口分布规模、交通地重要性和行政等级的特征;传染扩散模式随着媒介的变化而不断演进;依托海岛的跳板式扩散则是沿海地区基督教扩散的特殊形式.这些模式虽是从经典文化扩散模式演化而来,但在具体特征上已有显著变化.研究试图对传统的文化扩散模式进行重新解读,并为"腹地一口岸一市场"的文化扩散理论提供成熟案例.     

Glucose production from hydrolysis of cellulose over a novel silica catalyst under hydrothermal conditions

A novel silica catalyst was synthesized by evaporation-induced self-assembly (EISA) method and tested for the catalytic selective hydrolysis of cellulose to glucose. This silica catalyst exhibited a higher catalytic activity than other oxides prepared by the same method, such as ZrO₂, TiO₂, and Al₂O₃. Using silica as a catalyst, cellulose was selectively hydrolyzed into glucose with a glucose yield as high as 50% under hydrothermal conditions without hydrogen gas. The silica catalyst was characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD) and transmission electron microscopy (TEM). The results of temperature-programmed desorption of ammonia (NH₃-TPD) and textural properties indicated that the synergistic effect between strong acidity and a suitable pore diameter of the silica catalyst may be responsible for its high activity. In addition, the catalyst was recyclable and showed excellent stability during the recycle catalytic runs.     

Ammonia volatilization and availability of Cu, Zn induced by applications of urea with and without coating in soils

Ammonia volatilization and the distribution of Cu and Zn were investigated in two types of soil treated with coated and uncoated urea. The rate of ammonia volatilization in two weeks after fertilizing with coated urea was 8% in soil 1 (soil derived from river alluvial deposits in Dongting Lake Plain) and 5.15% in soil 2 (red soil derived from quaternary red clay), about half the rates observed when fertilizing with common urea, implying that the hydrolysis speed of the coated urea was lower than for common urea, and that the coated urea can increase nitrogen use efficacy. As for the availability of Cu and Zn, their concentrations decreased in the first week after fertilization, and then increased, which was contrary to the effect of treatment on soil pH. For example, when the pH was 7.99, there was 0.79 mg/kg exchangeable Cu and 0.85 mg/kg exchangeable Zn in the soil derived from river alluvial deposits in Dongting Lake Plain. However, the concentrations of exchangeable Cu and Zn were generally lower for the common urea treatments than those with the coated urea because the peak pH for the common urea treatment was greater. The concentrations of these elements correlated well with pH in the range 4-8 in second order polynomial fits.     

Fatty acids and algal lipids as precursors of chlorination by-products

Six common algal fatty acids (FAs) with different numbers of double bonds, lipophilic fractions and proteins extracted from the diatom Navicula pelliculosa and algal cells were chlorinated to evaluate their potential in generating disinfection by-products (DBPs). The result showed that the more double bonds in the FAs, the higher the amounts of chloroform and dichloroacetic acid (DCAA) produced, but such a pattern was not observed for trichloroacetic acid (TCAA). Based on the previously reported composition of fatty acids in algal lipids, the DBP generation potentials of algal lipids were calculated. These predicted values were much lower than those measured in the chlorinated algal lipophilic fraction, suggesting unknown lipophilic fraction(s) served as potent DBPs precursors. Another calculation attempted to predict DBP production in algal cells based on algal lipid and protein composition, given quantified measured DBP production per unit algal lipid and proteins. The analysis showed that the observed DBP production was similar to that predicted (< 35% difference), suggesting that algal biochemical compositions may serve as a bioindicator for preliminary estimation of chloroform, DCAA and TCAA formation upon chlorinating algae.     

氢氧化钽对水体中磷酸盐的吸附去除作用

采用氢氧化钽为吸附剂,对水中磷酸盐的吸附性能进行了研究,考察了吸附时间、pH值、磷酸盐的初始浓度、反应温度对吸附量的影响。实验结果表明:pH值越小,氢氧化钽对磷酸盐的吸附量越大,当pH值为2时氢氧化钽对磷酸盐的吸附性能优,并且pH值对磷酸盐的吸附量影响较大;磷酸盐的初始浓度越大,吸附量越大,吸附平衡时间越短;氢氧化钽对磷酸盐的吸附量和吸附速率都随着温度的升高而增加。在25℃、pH=2、初始浓度为200 mg/L、吸附30 min时达到平衡时最大吸附量为76.69 mg/g。吸附后的氢氧化钽红外谱图在1066 cm-1处出现特征峰,该峰恰好是吸附磷酸盐的伸缩振动峰,并且在638 cm-1与670 cm-1之间Ta-O键由于磷酸盐的吸附发生了蓝移。采用6 mol/L的NaOH对吸附了磷酸盐的氢氧化钽进行解吸,当pH=12时解吸率为52.45%。研究结果表明,氢氧化钽能够有效的去除水溶液中磷酸盐的吸附剂。     

污泥活性炭理化性质表征及吸附抗生素效果研究

文章以北京方庄污水处理厂的浓缩和脱水污泥为原料,采用ZnCl2活化法分别制备污泥活性炭。对制得的污泥活性炭进行表征,并将其应用于加替沙星废水的处理。研究2种污泥活性炭吸附反应的吸附时间、吸附剂投加量、pH值、初始浓度4个因子对吸附量的影响,设计正交实验。正交实验结果表明:2种污泥活性炭受到4个因子影响程度相当,表现出明显的相似性,但短期吸附时,脱水污泥表现出更好的吸附性能。初始浓度对吸附量的影响最大,获得最大吸附量的条件组合为:初始浓度200 mg/L,投加量0.05 g,pH=9,t=2 h。浓缩和脱水污泥活性炭的最大吸附量分别可达34.541 mg/g和34.925 mg/g,表明2种污泥活性炭对加替沙星均有良好的吸附效果。污泥活性炭作为一种废水吸附剂,是废水处理的一种新途径。     

基于循环特性的镍氢和锂离子电池环境影响机制分析

为了了解镍氢电池和锂离子电池在生产、使用、废弃或回收过程中的环境影响,建立了一种简单快速的二次电池环境影响机制分析方法。通过生命周期评价(LCA)方法,采用Eco-indicator99体系,综合考虑电池循环容量衰减和循环次数的影响,建立了二次电池环境影响机制分析模型,并运用此模型对两种实验用二次电池(镍氢电池和锂离子电池)的环境影响机制进行了研究。结果表明:1)在所选取的两种二次电池当中,锂离子(Li-ion)电池的环境影响明显比镍氢(Ni-MH)电池的低;2)随着循环次数的增加Li-ion电池环境影响衰减比Ni-MH电池的明显,即随着使用循环次数的增加,Li-ion电池对环境的影响会降低到更多。综合来说,所选取的Li-ion电池比Ni-MH电池更具环境可持续性。文中所提出的环境影响机制分析模型同样可以应用于其他二次电池,以期为环境友好型二次电池的开发提供帮助。     

水泥炉窑SNCR及SCR烟气脱硝技术比较

通过分析水泥炉窑氮氧化物(NOx)生成机理、脱除技术以及国内外水泥炉窑脱硝现状并结合我国具体情况,探讨适合我国的水泥炉窑切实可行脱硝技术,为"十二五"期间我国水泥炉窑开展烟气脱硝整治工作提供技术性方向。     

沸石和活性炭处理氨氮废水的实验研究

文章选用具有较强选择性和吸附性的13X沸石和活性炭作为吸附材料,以人工配置的含氨氮废水模拟实际废水,分别以溶液pH值、吸附时间、初始浓度和投加顺序等作为影响因素,通过实验来系统地考察所选材料对废水中氨氮的去除技术参数。结果表明:所选材料具有较好、较稳定的吸收效果,在其他条件一定的情况下,13X沸石在pH值为中性,吸附时间为40 min时对氨氮的去除率最大,达87.9%。且在相同实验条件下,先投放活性炭再投放沸石去除氨氮的效果较好,比先投放沸石然后投放活性炭的效果高出25%左右。     

山西省武乡县城大气PM2.5痕量重金属的生态和健康风险分析

为了解山西省武乡县城大气PM_(2.5)污染特征及PM_(2.5)中痕量重金属的生态和健康风险,在分析县城环境空气质量状况的基础上,分别于秋季(2014-10-22~2014-11-19)和冬季(2015-01-12~2015-02-13)在武乡县环境保护局楼顶用中流量采样器采集大气PM_(2.5)样品,每天换膜一次,利用称重法计算PM_(2.5)浓度,运用电感耦合等离子体原子发射光谱仪(ICP-AES)测定样品中As、Cd、Cr、Cu、Ni、Pb、Zn 7种元素含量,运用地累积指数法、生态风险指数法、相关性分析和主成分分析、美国环保署暴露模型等表征痕量重金属的污染程度、来源、潜在的生态和健康风险等.结果表明,冬季大气PM_(2.5)浓度是秋季的3倍左右,有65%的天数超过国家环境空气质量二级标准(GB 3095-2012);PM_(2.5)中痕量重金属来源主要包括燃煤和交通等人为源,贡献率分别为58.38%和18.73%,所测重金属浓度顺序为CuZnPbCrAsNiCd,其中Cd、Cu的生态风险指数、Cr的非致癌和致癌暴露风险大于其它金属.冬季燃煤增加和大气扩散条件差是武乡县城大气PM_(2.5)浓度超标以及造成痕量重金属生态和健康风险增大的主要原因.